RESION UV Resin Art Epoxy LV (luxury epoxy set)
- Luxury gift set
- Set with base and hardener
- Contents: 0.75 kg
Looking for a nice epoxy gift for your friend, family member or acquaintance? Then this luxury epoxy set is highly recommended. The set (A+B) is packaged in a nice package, which you can easily wrap up to give as a gift.
About RESION UV Epoxy LV
RESION UV Resin Art Epoxy LV is an epoxy resin specially developed for making resin art. This epoxy is of high quality, is easy to process due to the 2:1 mixing ratio and has a very high UV stability. This makes the low viscosity (LV) epoxy universally applicable for making jewelery, orgonites, paintings, coasters and other art on all types of surfaces. Are you a starting or experienced resin art artist, then RESION UV Resin Art Epoxy LV is the epoxy resin you've been looking for!
Benefits of RESION UV Epoxy LV
- High quality transparent epoxy.
- Very high UV resistant.
- Adheres to almost all surfaces (such as wood, concrete and plastics).
- Easy in use due to a 2:1 mixing ratio.
- Low viscosity (thin spread).
- Odourless.
How to use RESION UV Epoxy LV
Using RESION Art Epoxy is very simple if you follow the following steps:
- Weigh the base component (A) and the hardener (B) well according to the mixing ratio stated on the packaging (2 parts by weight of resin on 1 part by weight of hardener).
- Mix the base component and the hardener thoroughly for 3 minutes. Also scrape well along the side and bottom of the mixing cup!
- If desired, add pigments to colour the resin.
- Apply the epoxy to the surface you will use (the processing time is 30-60 minutes at 20℃).
- After application, allow the Art Epoxy to cure for approximately 12-18 hours before it is manageable (note: it takes 3-5 days before the epoxy is fully cured).
Product properties
| Packaging | Resin (EP 102) | Hardener (EP 124) |
| 0.75 kg | 0.5 kg | 0.25 kg |
Mixing ratio: 2:1 (100 grams of resin, 50 grams of hardener)
Processing time: 30-60 minutes at 20°C
Minimum processing temperature: 12°C
Dust dry: after 6-12 hours (20°C)
Manageable: after 12-18 hours (20°C)
Full curing: 3-5 days
Heat resistance: 40-45 °C
Maximum casting thickness: 2-2.5 cm
We have a number of recommendations for working safely with polymers. At Polyestershoppen you will not only find the polymers themselves, but you can also purchase all the protective equipment you need from us. If you have any doubts or questions, please contact our customer service. We can give you advice on how to work safely with polymers.
