Non-perforated release film
At a glance
- For prepreg applications
- As vacuum film
- As a mould surface
Non-perforated release film (NP) is a flexible and strong polyolefin release film with very high elongation. The film is non-perforated and is used where release without resin bleed-through is required. The film prevents resin from adhering to the surface, allowing the film to be easily removed from the cured laminate. This makes the product suitable as a release medium for a wide range of composite applications, both on laminates and on moulds where controlled release is required. Due to its high flexibility and elongation, the film is easy to apply, even around smaller and more complex shapes.
The film can also be used as a thin vacuum film. The combination of flexibility, strength and high elongation makes this release film particularly suitable for smaller objects and laminates.
Release Film (NP) Features
- Non-perforated release medium that prevents resin bleed-through.
- Very high elongation and flexibility.
- Can also be used as a thin vacuum film.
- Suitable for complex and smaller shapes.
Specifications
Material: polypropylene
Perforation: none
Colour: red
Thickness: 30 μm
Recommended processing temperature: 150 °C
Maximum temperature: 157 ºC
Elongation at break: 500%
Tensile strength at break: 42 MPa
Dimensions:
- Roll 150 cm x 5 metres (7.5 m2)
- Roll 150 cm x 20 metres (30 m2)
- Roll 150 cm x 100 metres (150 m2)
Product properties
The key technical properties clearly listed in one place.
- Article number
- VAC001269
-
The technical product category, such as primer, resin, hardener or cleaner. It explains the product's purpose and helps you find other products with a similar function.
- Gaatjesfolie
-
The recommended application temperature range indicates the conditions under which the product can generally be applied and cured properly. Three temperatures matter:
- Air: the temperature in the workshop or outdoors.
- Substrate: the temperature of the surface being treated.
- Product: the temperature of the resin, adhesive or coating itself.
A cold substrate can cause condensation and affect adhesion. At higher temperatures, two-component products may react faster, reducing their working time. Check the dew point and follow the product instructions.
- 150 °C
-
The product's dimensions, usually shown as length × width × height or another product-specific order. Check whether the measurements describe the outside, inside or usable space, especially for containers and moulds.
- 1.5 x 5 m
-
The physical thickness of the supplied material, such as a panel, pad, film or foam sheet. This differs from the thickness of a liquid coating applied to a surface.
- 0.03 mm
-
The arrangement of extraction holes in a sanding disc or backing pad. A matching hole pattern helps remove sanding dust. Check that the holes line up with the backing pad and dust extraction system.
- None
-
The base material a product or part is made from, such as HDPE, aluminium, glass fibre or foam. Material choice affects weight, stiffness, chemical resistance and how the part can be worked or processed.
- Polypropylene (PP)
-
Elongation at break indicates how much a material can stretch during a tensile test before it breaks. It is expressed as a percentage (%) of the original length. At 100% elongation, the material has doubled in length just before breaking. A high value indicates a high ability to deform, but not how much force is needed.
- 500%
-
Tensile strength is the maximum tensile stress a material can withstand during a tensile test before failure. It is usually expressed in MPa (megapascals) or N/mm² (newtons per square millimetre); 1 MPa = 1 N/mm². Under comparable test conditions, a higher value means greater resistance to tension. In composites, fibre orientation also affects the result.
- 42 MPa
Reviews
Frequently bought together
Useful additions for your project.