Araldite Instant 90 sec. Epoxy Adhesive
At a glance
- Solvent free
- Fast curing
- No application gun required
Not sure about your choice?
Want to know which Araldite adhesive you need? Use our selection tool!
Araldite Instant 90 seconds Epoxy Adhesive is a solvent-free, fast-curing, two-component epoxy adhesive.
Features of Araldite Instant 90 Seconds epoxy adhesive
- Good chemical and water resistance.
- High impact and shock resistance.
- Ultra-fast curing.
Applications
- Various metals.
- Various plastics (except PP and PE).
- Glass, quartz and gemstones.
- Wood.
- Leather.
- Ceramics.
- Rubber.
Specifications
Adheres to: glass, quartz, rubber, leather, wood, various metals and a wide range of plastics (except PP and PE)
Can be loaded and painted after: approx. 2 hours
Temperature resistance: -30 °C to +65 °C (after curing)
Colour: opaque
Packaging: 24 ml dual syringe
Product properties
The key technical properties clearly listed in one place.
- Article number
- LIJ000766
-
Adhesive type describes the family of adhesive or sealant, such as epoxy adhesive, (methyl)methacrylate adhesive, polyurethane adhesive or polymer sealant. Its chemistry affects processing, curing, flexibility and adhesion. Products of the same type may still differ, so check the suitable substrates and application instructions.
- Epoxylijm
-
Open time is the period during which an applied adhesive, sealant or mortar can still be assembled, positioned or adjusted. It is usually given in minutes under specified conditions, often around 20 or 23 °C. Open time generally starts at application and may differ from the working time after mixing.
- 1 tot 10 minuten
-
This property lists the substrates on which an adhesive, resin or coating can achieve strong adhesion according to the product information. The result also depends on surface preparation.
- Cleaning and degreasing: removes dirt, oil and other substances that interfere with bonding.
- Sanding or roughening: can improve adhesion when suitable for the substrate.
- Primer: required or recommended for some surfaces.
Materials such as PE, PP and PTFE are difficult to bond with many conventional adhesives and may need a specialist adhesive or pretreatment. If in doubt, test adhesion on a small area.
- Staal, Roestvast staal (RVS), Beton, Glas, Keramiek, Hout, Rubber, Metal, Leather, Quartz, Plastics (except PP and PE)
- Net contents
- 24 ml dual syringe
-
Heat resistance describes the temperature a material can withstand after correct processing and curing, usually expressed in degrees Celsius (°C). Continuous exposure is different from a brief temperature peak, and mechanical loading may also affect the limit. Heat resistance is not the same as the temperature at which the product can be applied.
- -30 to 65 °C
Safety information
Read the warnings and use appropriate protective equipment before handling the product.