Westlake MGS BP20 bonding paste
- Professional epoxy adhesive
- For composite-metal bonding
- Pot life: 15 minutes
Westlake BP20 is a high-strength epoxy adhesive that is particularly suitable for fast-curing bonding applications in wind energy composite structures and for bonding composites and metals. This adhesive is especially suitable for bonding and repairing wind turbine blades.
Westlake BP20, also known as Epikote Resin MGS BP20, cures well even at low temperatures. Good mechanical properties develop already 24 hours after the initial cure. Full mechanical strength and thermal resistance are achieved after a post-cure (3 hours at 50–60 °C).
Packaging
MGS BP20 is available in cartridges of 400 ml (side-by-side) and 216 ml (U-TAH cartridge) and is therefore ideal for precise and clean bonding. This epoxy adhesive should only be used with the correct mixing tubes that ensure good mixing and low pressure loss.
- 216 ml
Mixing tube: D
Application gun: sealant gun for cartridges - 400 ml
Mixing tube: E
Application gun: LS400-2 (2:1)
Benefits of Westlake BP20 bonding paste
- Fast adhesion to composites and metal.
- Long processing time (15 minutes).
- Developed for professional applications, but also suitable for DIY projects.
Directions for use
We recommend using this bonding paste in the following way:
- Remove cap nut and plug.
- Squeeze out material until the hardener and resin are at the same level.
- Attach the mixing tube and secure with cap nut.
- Reject the first 5-15 grams until colour is homogeneous.
We recommend storing BP20 in the dark (without exposure to direct sunlight or UV) at temperatures between 15-30°C. The material does not tend to crystallize, but lower temperatures make processing more difficult. MGS BP20 can be stored for up to 24 months in the original unopened cartridges. When processing MGS BP20 at low temperatures, the cartridges should be warmed up to 20-40 °C before use.
Specifications
Colour: yellow (base), blue (hardener)
Mixing ratio: 2:1
Packaging: 216 ml or 400 ml cartridge
Density: 1.19 g/cm3
Pot life: 15 minutes
Gel time: 100 minutes
Minimum processing temperature: +10°C
Shelf life: 24 months in the original packaging
We have a number of recommendations for working safely with polymers. At Polyestershoppen you will not only find the polymers themselves, but you can also purchase all the protective equipment you need from us. If you have any doubts or questions, please contact our customer service. We can give you advice on how to work safely with polymers.
