GLOO ARS1217 Epoxy Adhesive
At a glance
- Epoxy adhesive
- Alternative for Araldite 2014
- Long processing time
GLOO ARS1217 is a two-component epoxy-based self-leveling adhesive. This alternative to Araldite 2014 has a 2:1 mix ratio and offers a long pot life. GLOO ARS1217 is ideal for bonding metals (under heat curing conditions) as well as plastics.
Features
- Long potlife.
- Good resistance to dynamic loads.
- Low shrinkage.
- Cost-effective alternative for Araldite 2014.
Applications
GLOO ARS1217 is suitable for bonding the following materials:
- Ferrous metals, as well as aluminium, copper, zinc and galvanised products.
- Glass fibre reinforced plastics and epoxy resins.
- Fibre reinforced polyester.
- Thermosetting composites.
- Ceramic materials.
- Wood.
Directions for use
Before bonding, it is important that the surface is dry, grease-free and dust-free. If needed, you can sand the surface with P40-P280 sandpaper. Remove dust and degrease again. Use gloves to minimise skin contact. Remove the cartridge cap and dispense a small amount of adhesive to be sure both components flow evenly. Close the cartridge immediately after use. The adhesive can be sanded, painted, etc. after approximately 30 minutes.
Specifications
Packaging: 50 ml & 400 ml
Mixing ratio: 2:1
Viscosity: thixotropic
Glass Transition Temperature (Tg): 73°C
Pot life: >60 minutes
Full cure time: 24 hours (fully cured after 7 days)
Application gun: Application gun LS50-1 (50 ml)
Mixing tubes: Mixing nozzle C (50 ml)
For more information, please refer to the GLOO ARS1217 technical documentation.
Product properties
The key technical properties clearly listed in one place.
- Article number
- LIJ001756
-
Adhesive type describes the family of adhesive or sealant, such as epoxy adhesive, (methyl)methacrylate adhesive, polyurethane adhesive or polymer sealant. Its chemistry affects processing, curing, flexibility and adhesion. Products of the same type may still differ, so check the suitable substrates and application instructions.
- Epoxylijm
-
Open time is the period during which an applied adhesive, sealant or mortar can still be assembled, positioned or adjusted. It is usually given in minutes under specified conditions, often around 20 or 23 °C. Open time generally starts at application and may differ from the working time after mixing.
- meer dan 60 minuten
- Net contents
- 400 ml, 50 ml
-
Viscosity measures how easily a liquid flows, or how thick it is. Dynamic viscosity is usually expressed in mPa·s (millipascal-seconds), sometimes in cP (centipoise); 1 mPa·s = 1 cP. A lower value usually means a more free-flowing liquid, while a higher value indicates a thicker product. Temperature and test method strongly affect the value. Note that mPa·s is different from MPa, which is used to express mechanical strength.
- Thixotropic