Silicone mould for a large dish
- For epoxy dishes
- Diameter: 25 cm
- Contents: 292 grams of epoxy
Making your own bowl out of epoxy? Then this cool mould is just what you are looking for! The silicone mould has a slightly ribbed pattern on the side and bottom. This gives the dish the look of a sawn tree trunk.
You can use the mould several times. The end result is easy to remove from the mould. Want to make unloading even easier? Then use our release spray. This will extend the life of the cast. Be careful not to use too much of this, as it can make your cast dull/matt.
Suitable epoxy resin
Using suitable epoxy is important for the end result of your creations. Do you want to use epoxy that is highly UV-resistant and easy to process? Then choose RESION UV Resin Art Epoxy LV (low viscosity). Because this epoxy does not discolour under UV light, you do not need a stabiliser. For all epoxy resins, see the Epoxy category.
Make unique Resin Art with these pigments
With epoxy pigments you can give your epoxy bowls a unique twist. Give the dishes a nice opaque colour with Resi-TInt MAX or a luxurious glitter look with MetalTint mica powder. Or do you prefer a transparent look? Then use RESION TransTint. Check out our entire range of pigments to see which ones suit you!
Product properties
Shape: cross section of a tree trunk
Material: silicone
Diameter: 20 cm
Edge: 3 cm
You will need approximately 292 grams of epoxy for these moulds.
We have a number of recommendations for working safely with polymers. At Polyestershoppen you will not only find the polymers themselves, but you can also purchase all the protective equipment you need from us. If you have any doubts or questions, please contact our customer service. We can give you advice on how to work safely with polymers.
