BILTEC Vacuum pump with valve and gauge

BILTEC vacuum pump for venting casting resins, for vacuum injection (Resin Infusion), for drying materials such as mobile phones, making essential oils, and numerous other applications!

This vacuum pump is quiet, easy to use and performs well. In addition, the pump has a vacuum gauge so that you can accurately monitor the pressure. The vacuum pumps are also equipped with an electrically operated valve. This valve opens when the pump is turned on and closes when the pump is turned off. This prevents air from entering your project when the vacuum pump is off.

Features vacuum pump

• With electric valve and vacuum gauge.
• Low noise.
• Easy to use.
• Equipped with electrically operated valve.

Instructions for use

Follow the instructions below to use the vacuum pump and watch the video. The full manual can be found under the 'Documents' tab.

Before use:

• Fill the pump with the supplied oil until it reaches halfway up the sight glass.
• Check that the hose barb is properly secured and the rubber ring is present.
• Connect the pump to your project in an airtight manner.

During use:

• Switch on the pump using the switch on the back.
• The pump will initially make a rattling sound, which will change to a humming noise once vacuum is achieved (this may take a few minutes).
• The pump housing may become warm; this is not a problem for the pump.
• Monitor the oil level and top up if necessary.

Specifications

Connection: 8 mm hose barb
Gauge: 0-1000 mbar
Voltage: 230 volt
Final vacuum: 0.05 mbar of 0.003 mbar
Noise level: ca. 55 dB
Switch: on/off, mounted on pump body

Scope of delivery:

• Vacuum pump with gauge and valve.
• Vacuum oil.
• Manual.